Redmi 10 Prime (selene_in), since it uses a MediaTek (MT6768/MT6769) chipset, you don’t necessarily need a specific “unlock file” if you use the MTK Auth Bypass method. You can perform a Mi Account and FRP reset using free tools like MTK Meta Utility or SP Flash Tool.
Below is the technical breakdown for bypassing the locks on this model.
1. Free Method: MTK Auth Bypass + SP Flash Tool
This is the most reliable free method to bypass Mi Account and FRP without purchasing credits.
MTK Auth Bypass Tool (e.g., MTK Meta Utility or MCT Auth Bypass).
SP Flash Tool (v5.21 or higher).
LibUSB Win32 (to filter the MediaTek USB port).
Scatter File: Extract the MT6768_Android_scatter.txt from the official Fastboot ROM for selene_in.
FRP Address (Manual Format):
Physical Start Address:0x19000000
Partition Size:0x100000(Note: Always verify these addresses in your specific scatter file under the “frp” partition.)
2. Mi Account Bypass (Free Utility)
To remove the Mi Account lock, you can use the MTK Meta Utility (Free Edition):
Open the utility and select the Xiaomi tab.
Click on Mi Account Reset / Disable.
Power off the phone.
Hold Volume Up + Volume Down and connect the USB cable.
The tool will trigger the exploit and bypass the account lock in seconds.
3. Hardware Test Point (EDL/MTK Mode)
If the device is not detected by holding the volume buttons (due to a disabled preloader), you may need to use the Test Point:
The test point for selene_in is located near the battery connector (two small gold dots). Shorting these while connecting the USB will force the device into MTK USB Port (COMxx) mode.
Important Technical Notes
Anti-Relock: After bypassing the Mi Account, do not connect to Wi-Fi immediately. Go to Settings and Disable Find Device and Mi Cloud Sync to prevent the device from relocking.
Drivers: Ensure you have the MediaTek VCOM USB Drivers installed. If the tool stucks at “Waiting for device,” check your LibUSB filters.
Firmware: If you need to flash the full device, ensure you use the India-specific (selene_in) firmware to avoid “System has been destroyed” errors.
Warning: Performing these actions will wipe all user data. Ensure you have authorization to unlock the device.rposes only. Please use these methods only on devices you own or have legal permission to service.
